Fielding DSP – Reviver 1.3.6 – R2R – NO INSTALL, SymLink Installer (VST, VST3) [WiN x64]

By | April 9, 2020

 

Year / Release Date : 02/28/2020
Version : 1.3.6
Developer : Fielding DSP
Developer’s site : Fielding DSP
Format : VST, VST3
Bit : 64bit
Tabletka : cured | R2R
System Requirements : Windows: 7, 8, and 10


Description : This plug-in increases the volume of the signal, adds brightness and β€œfat”, changes the character of the sound of the second and third harmonics. Unlike many other plugins in this category, Reviver does not add any digital junk to the signal. This can be avoided thanks to internal upsampling, i.e. processing at a higher sampling rate, followed by conversion back to the standard frequency. Reviver is not trying to simulate any single analog device. It aims to provide the user with complete control with a convenient interface.
Technical Details:
Supported sampling rates: 44.1, 48, 88.2, 96, 176.4, 192 KHz.
Internal upsampling up to 768 kHz (at 192 kHz).
32-bit precision internal processing.
Monophonic and stereo modes.

02/28/2020 Update: Replacement for release from R2R


Installation :
A) SAVING OPERATIONS, delete folders left over from previous installations;
B) run SymLink Installer.cmd (if you need to change the path to VST2, see below)
C) launch DAW by setting the scan path C: \ Program Files \ VstPlugins, scan for new plugins.
In the case when β€œmanual” registration with keygen, patch, etc. is required, everything necessary will be in the REG folder
{0} {Preinstall the required system software}
The following must be installed in the system:
Microsoft Visual C ++ 2005-2008-2010-2012-2013-2019 Redistributable Package x86 & x64
forum.oszone.net/thread-145766.html
{1} {Proper package unzipping}
Run .exe or open the package file with the 7-zip.org archiver (without using drag and drop),
extract its contents to any drive for permanent storage *,
not deep in the nesting of folders, briefly by name, from letters, numbers, spaces, underscores, periods,
without other non-literal characters, without Cyrillic and other national alphabets
* For the correct operation of symlinks, MOVE, DELETE, RENAME ANYTHING IN THE PACKAGE IS UNACCEPTABLE.
{2} {Removing traces of other versions of the package}
{2.1} ATTENTION! Save the operating time (presets, etc.) of the deleted.
{2.2} Uninstall (or uninstall if there is no uninstaller) previous versions of the installation.
{2.3} Check the absence of folders in the places where the symlinks were created (IF FOLDERS ARE LEFT, THEN SIMLINKS WILL NOT BE CREATED)
and delete the folders remaining after uninstalling.

One thought on “Fielding DSP – Reviver 1.3.6 – R2R – NO INSTALL, SymLink Installer (VST, VST3) [WiN x64]

Leave a Reply